0.620" High Temp Vinyl Insertion Plug (MCP9256T) Material: Black High-Temp Vinyl
SKU
MCPC9256T-05
① Configure your item
?
MOCAP
Dip-Molded Vinyl
Black
Red
1795CWhite
Gray
422CYellow
7404COrange
1665CGreen
347CGreen (Dark)
1308CBrown
462CBlue (Dark)
295CBlue
3015C
SKU# MCPC9256T-05
- Buy 102 for $56.03 ($0.5493 each)
- Buy 1020 for $281.11 ($0.2756 each) and save 50%
- Buy 10200 for $541.62 ($0.0531 each) and save 90%
- Buy 102000 for $4,559.40 ($0.0447 each) and save 92%
- For larger quantities, please contact us for a custom quote.
Click to get a shareable link to current item config
Copied to Clipboard
High Temp Vinyl Insertion Plugs (MCP-T)
MOCAP High Temperature Vinyl Plastic Masking Plugs are a low cost quality answer to your masking needs. Flexible material allows these plastic plugs to seal threaded and non-threaded openings. Special high temperature resistant vinyl material withstands up to 475°F(246°C).For more information, see our MCP-T Series page.
Additional Information
NOTE: Due to the inherent variability of the dip-molding process, the "Flange OD" may vary by +/-1.6mm (1/16") from the figures shown above.
Wall thickness is measured approx. ¼” (6.35mm) from open end. Wall thickness increases slightly towards the closed end of the part
Micropacks are only available for purchase through our online store.
MOCAP High Temperature Vinyl Plastic Masking Plugs are a low cost quality answer to your masking needs. Flexible material allows these plastic plugs to seal threaded and non-threaded openings. Special high temperature resistant vinyl material withstands up to 475°F(246°C).
For more information, see our MCP-T Series page.
NOTE: Due to the inherent variability of the dip-molding process, the "Flange OD" may vary by +/-1.6mm (1/16") from the figures shown above.
Wall thickness is measured approx. ¼” (6.35mm) from open end. Wall thickness increases slightly towards the closed end of the part
Micropacks are only available for purchase through our online store.